Review on Winunite F150 Cup Holder Insert Replacement - Fits 2004-2008 Flow Through Console FX2/FX4/Lariat/King Ranch, 2003-2006 Expedition - 1 Set by Sedric Hood

These front cup holder inserts do a good job of keeping my drinks from flying all over the cockpit of my F-150 and they look great with a black lasso. Inner. They are made of durable, molded and somewhat pliable plastic that is easy to install and can also be removed (and reinstalled) for easy cleaning with water. They appear to be made to last. The only issue I had with the inserts was that the side panels (the flat tabs on each of the inserts) were too long to sit flat when reassembled. (I lost one star because of the fit, and that's not true.) Check your fit before you cut it, especially if you're only replacing one. I had to remove about an eighth to a quarter of an inch. I cut both inserts to fit together in the console. It wasn't too difficult, but I didn't expect to have to do it either. I used a razor blade with a *new blade* for a clean cut because the material is pretty strong. A dull blade will leave a rattling noise on your cuts. I removed a bit from each end until they matched and looked even. Looking back, I don't even notice the cuts I made after installing the cup holders. I could have just removed the extra length from one of the inserts, but being a perfectionist (that's what I call myself - different people use different words) I didn't and did the extra work myself. (I'm just trying to help you - you can learn from my mistakes!)