Review on ⚡️ Reliable & Certified Lightning Charging Compatible Projector Industrial Electrical Wiring & Connecting Solution by Brenda Hofheins

Figure is very poor but does the job. The screw provided to secure the drive is not long enough to go through the plastic bar when using the longer 2280 drive. The set screw cannot be screwed into the set pin on 2280 actuators, it just isn't long enough. It seems fine for the 2260 drive I was trying to mount. In order for the 2280 drive to accommodate the screw I had to remove the circuit board from the case and screw it in and then put it back into the case, alternatively I could trim the case screw mount slightly to allow for the screw to sink in. a little. There is a lot of play when securing the drive as the locating pin only secures the drive from above, allowing you to push it against the motherboard. He's not protected at all. When using a 2280 disc, the board flexes a lot, the board is very thin, and the tubing doesn't really help protect or increase stability. Works great for an M-Key NVMe 2280 drive (installation issues aside) macOS. However, this didn't work for the B+M Key 2260 drive, Windows or macOS picks up the B+M key and you only get 1 LED that doesn't blink, which I think is some sort of bug. Bottom line, it's cheap and it works. The installation is very poor, expect to have to modify the case to get everything working properly. Would I trust that for mission-critical data, absolutely not. Poor fit, bad drive mount and no thermal management. I wouldn't trust him with anything important. Long term use should be fine but I would caution against handling the drive as it gets hot.