Review on 🔥 Enhance Your Camping Stove Experience with Jetboil Stainless Steel Pot Support by Sean Burnett

The color confuses me. Geometry was my favorite subject at school. However, it took me a while to figure out how this block "fits" to my MicroMo torch (which is basically the same as the MiniMo and some others in terms of "fitting"). I couldn't mount it on the burner and figured the problem was that the tabs on the bottom needed to be bent to allow the entire block to slide into the burner rim. NOT CORRECT! I fiddled with the protrusions with needle nose pliers, pressing and clamping the block onto the burner. Then the light went on! All you have to do is rotate each of the pot holders 90 degrees. The slots on the bottom of the four thumbtacks are now aligned with the edge of the burner. Put it back and twist to attach it to the burner. You may need to check carefully where you mount it on the rim, but once you line up the slots on the bottom of the four pins with the rim, everything else is easy and it fits perfectly. I was in the "it's not tight" camp for about an hour. Once I figured that out, the device went from one star to five stars in a flash! I do not want it. Once I figured it out, I liked it. My dissatisfaction was entirely due to my inability to figure out how to rotate the four potholders. Again. The color confused me - about an hour.