
Remove the protective plastic bubble to see which pin is GND, 5V and OUTPUT. I connected them to my Arduino. Set the pin as INPUT and again as INPUT_PULLUP and it will never move from HIGH. I've searched the web for clues, tried the ones I found, but these things seem useless. First Arduino sensor/component/something in 5 years that was NOT BAD out of a foil bag. Say hello to my little trash can.

π Chamberlain Group CWA2000 Chamberlain Driveway Alert: Enhanced Security in Sleek Black Design
10 Review

Wireless Driveway Alarm System - Long Range 1/2 Mile with Solar Power & Weatherproof Design - Adjustable Sensitivities and Outdoor Motion Sensor for DIY Security Alert
11 Review

πΈ Datacolor SpyderX Pro SXP100 β Advanced Monitor Calibration for Professional Photographers and Designers
10 Review

Optimized 433MHz Home Wireless PIR Infrared Motion Detector Sensor for Alarm System by KERUI
12 Review

π TalentCell PB240A1 | 24V Lithium Ion Battery with 22400mAh Capacity | Rechargeable Power Pack for LED Light Strip, CCTV Camera, Smartphone & More
26 Review

Dingsun SVideo To HDMI Converter: 3RCA AV Support 1080P/720P Compatible With WII U, PS2/PS3, STB, Xbox & More!
43 Review

Enhance Your Network Connection With Dingsun RJ45 Coupler - Compatible With Cat5, Cat5E, Cat6, And Cat7 Ethernet Cables (Black 10 Pcs)
35 Review

Fitbit Versa 3 Smartwatch Replacement Band: TOYOUTHS Elastic Nylon Fabric Strap For Women & Men
50 Review