Used for two pieces of 304 stainless steel, 20 gauge. Both cleaned with alcohol. "Grubbed" their flip disk. I mixed the binders and applied to one piece and then bonded with a C clip for 24 hours. After 24 hours I untied them and then tried to separate them. Either I have some sort of high-performance capability to rip connected stainless steel pieces apart at 4500psi or this stuff isn't working as advertised. To be honest I would just like to know what I could have done wrong than to give this epoxy a negative review. Should the stainless steel parts have been better "cleaned"? Using a petal disc may have just polished the metal. Maybe I should use a hard drive instead of a flip drive for this prep? In any case, this is not possible out of the box and according to the recommended preparation of the material.
POR-15 Patch - 4 oz White Filler & Seam Sealer for Steel, 🔧 Wood, and Plastics - Ultimate Adhesive to Strengthen Weakened Metal and Patch Holes and Cracks
12 Review
🧽 Vdera SPLAT-AC-3P Splat Orange Auto-Clean Cleaning Putty - 3 oz.: The Ultimate Solution for Easy and Efficient Cleaning
10 Review
Permatex 82180 Maximum Resistance Silicone
9 Review
Loctite Red 262 High-Strength Threadlocker - 1.69 fl. oz. Bottle (26231)
11 Review
144-Pack Microfiber Cleaning Cloths - Non-Abrasive, Reusable & Washable (12X16In) | Amazon Basics Blue/White/Yellow
31 Review
10.2" Tablet Apple iPad 2019, RU, 32 GB, Wi-Fi + Cellular, silver
84 Review
Gaming chair COUGAR Armor One, on wheels, eco leather, black/orange [cu-armone]
53 Review
Complete 9-Piece Detailing Brush Set For Ultimate Car Deep Cleaning: Perfect For Cleaning Interior And Exterior, Wheels And Engine Dashboard With Boar Hair And Wire Brushes
12 Review