Review on 🛠️ Creality Original 3D Extruder Assembled: Enhanced Performance with Easy Setup by Adam Krueger

Does not fit my Ender 3! Firstly I loved this hot end, it not only came with improved insulation (mine was the old taped one) but also a blue teflon coating. A tube! Although it's made for a printer half the size when worn. The wires were half the length of my original hot end, which I took out. Path. higher and will not extend it left and right the full distance. Not sure about the Ender 3 Pro, but my Ender 3 had green posts that you screw the hot-end wires into. The wires were not only short, but also slightly thicker than the original. Luckily I had the right spare screws with me. However, one screw was countersunk and I filled the aluminum block a bit to get the screw in further. Finally, there were no additional attachments! I don't know if I received a used order, everything seemed new and whole. I'm almost afraid to turn on my printer if it's a bad hot end, I don't want my board to fry. 1/5*