Review on 3M Headlight Restoration System 2 Pack by Jesse Stewart

This product is amazing! I don't usually write reviews or post photos, but this product exceeded my expectations. I have a 2009 Hyundai Santa Fe and the highlights got so blurry it was distracting; and ride and watch. So going shopping to restore them would easily cost me over $70. Of course my brain is in a frenzy, let's do it with our own hands, and I immediately had memories of Pinterest! After many reviews and many views on YouTube, I decided on the 3M kit. I bought two sets based on the size and extent of the damage to my headlights based on reviews' recommendation. After receiving the kits and reading the instructions a few hundred times (also on YouTube again) I was good to go! I used masking tape to frame the headlight and I already had a cordless drill so I was ready to go! In the beginning you doubt your judgment and whether you made the right decision. Don't worry, it will work and the drill will keep moving over the headlight. I will tell you that the first step in the grinding process is the most important. If you take your time and work hard on the first part, the other steps are much easier! It took me about a day to make the headlight, mostly because I had to reload my drill (Harbor Freight less than $20). I bought a UV headlight spray from Wal-Mart to seal the headlight when I'm done. I used one set per headlight which I recommend. In general, the only major investment is your time and energy. The results have paid off!