Review on 🛠️ bROK 12" Aluminum Ramp Kit: Universal Wood Plank Ramps for Lawn Tractors, ATVs, Dolleys, and Wheelbarrows by Joseph Quintana

Just bought this kit and am very happy with it. I have a barn and the height above ground is much higher than I thought (16-18 inches). I was going to use 2 2X12's for the stringers but obviously 12" isn't enough. I've looked everywhere and found I can use this Brok solution. It's really easy to install. Just line up and mark the holes and add a 5 /32" Drill hole in 2X12. After that, drive the screw through the board; Then attach the kit to the board and tighten the screws. I have a 4' 2X12 and the diagram recommends using a 5 1/2' ramp. However, 4 foot boards worked fine. I also bought ramp ends from another seller but didn't really need to use that. I have a 28 inch snapper mower that weighs 300 pounds. I highly recommend this product.