Review on 🚲 VGEBY 9mm Quick Release Skewer Adapter Conversion for 100mm Mountain Bike Front & Rear Wheel Axle Hub by Joseph Harkins

This part is so terrible. First: The threads on the axle are very bad. For example, a used faucet had to be disposed of 1 million times ago. All nuts on the shaft are severely loosened due to out of specification tolerances. I have no doubt they will break, at least after a couple of torque applications. Second, the bearings are too small to fit properly in the hub. This BMX bike uses some basic JoyTech hubs and is nothing special. The bearings are 26mm OD and my hub is 29mm OD. I bought another axle that was labeled on the back but was in the front. They appear to be made in the same factory in China and use the same fake front and rear bearings. I have a 24mm front hub. The bearings have a width of 8 mm and a shaft diameter of 10 mm.