Review on 🚗 Loncky Black Custom Steering Wheel Cover for Toyota Tacoma 2012-2021, Tundra 2014-2021, 4Runner 2010-2021, Sequoia 2014-2021 by Evan Hernandez

***2 year update*** The cover is still great. With a few flaws I had for not being a professional steering wheel cover installer, in the end I even doubt it. A factory fitted leather steering wheel would look 2% better, but that's damn close. As many say, this installation took forever. However, I may have been more upset than necessary. I watched a few different videos and read the instructions and they all did it a little differently. The only thing I would do differently is definitely put a ton of double sided tape on before it gets on the wheel. Several different videos have done this in different ways. That's great! The Tundra steering wheel is actually very complex and takes forever to craft. Errors on the side too much overlap, especially below, than not enough. It's very tight, but it's amazing how much you can fit in. I have a problem area, the right side. I think I was too busy guiding a thread twist from left to right. If I could do it all over again I would start on one side, then finish at the top, then start on the other side and hit at the top. I think it might help me anchor the pages where there's a lot going on a little better. My plan is to get a hypodermic needle and inject some superglue to try and tie a few spots that are a little loose, especially on the back, and when I have enough energy I'll tell you how to do it. Overall, this item looks and feels fantastic. It took me six hours but I think I could do it in half the time if I did it again. I hope I never have to do this again!