Review on 🔪 NT Cutter Mat Board Cutter, 45 Degree Bevel, 1 Cutter (MAT-45P) by Jim Chick

I do a lot of crafting and crafting. I carefully followed the advice of others and watched several tutorial videos on YouTube. I used a strong steel ruler pressed firmly against the edge. The cuts came out clean except for the corners where they didn't go through because I didn't want to cut too far past them. If you go over this area again it's a mess - you can only make one proper cut for a clean edge. Also, it wasn't easy to figure out where the cut would be based on the instructions on the device. Get ready for some dry runs to see where the cuts are taking place.