Review on 🖼️ Logan ProFrame F300-1 Studio Joiner by Heather Shaw

This is the first time I'm using a tool like this and when I just followed the instructions it worked but just a few issues that aren't that important but implemented as improvements could become ; 1. The "trim spacer" could be improved as it just lifts the corner clamp 3/4" off the base so the moldings don't touch the base. So when you finally put the first V-nail in, the beveled ones will bend Edges of molding down as there is no support underneath. A small rubber pad must be used for this support. " must be used to prevent bending at the opposite corner. I finished a 64" x 42" photo frame where I had a makeshift alignment for the other end and didn't use a washer just a piece of rubber to protect the bar but also used V-nail supports to protect. After that everything worked perfectly! When I was done this large frame was a perfect rectangle and solid! This tool is definitely worth the money, but a few improvements could be used, but don't worry, you get perfectly square shots.