Review on 🔦 Auxbeam H13 9008 LED Light Bulbs: 8000LM 6500K Cool White, F-S3 Series with Fan & EMC - Pack of 2 by Aaron Stewart

(Used in my 2008 Jeep Liberty LE - H13 version - reflective) *My two cents only from searching google and youtube just to make sure my LEDs are installed correctly and working properly. * Make sure your LED chips are pointing in the right direction, for a typical 2-sided LED you will need to place the chips side by side or horizontally. 3 sided LED chips, you should have 2 chips (low beam) facing up to the ceiling of the case and the last chip (high beam) facing down. How to distinguish 2-1 is that 2 low beam chips are closest to the lamp tip and one high beam chip is farthest to the rear. The light emitted by these lamps is fantastic and very bright, just installed them. *yesterday* (so no durability check) but there are some minor issues with them. They seem to have a very faint flicker/flash effect which I assume is due to the wiring as they don't fit the connector properly despite being the correct type of bulb. Also, when using a Bluetooth radio I only get a lot of static electricity when the light is on, but using the extra cable I have no problem. The high beam is barely visible as if the low beam were the high beam and vice versa (but I'm guessing it's due to the 3-way placement of the LED chip considering I haven't swapped yet *oops* lol). Also, they are fantastic, I'm sure some of the issues I have are by my side and need to be addressed by me. Regarding radio interference, I did my "two cent research" and found that ferrite chokes help with this because the fan motor coming from the bulb is interfering with radio waves or something else.