Header banner
Revain logoHome Page
Ada Nadolna ᠌ photo
1 Level
162 Review
0 Karma

Review on 3D Printer Creality Ender 3 Pro Black by Ada Nadolna ᠌

Revainrating 4 out of 5

I like everything, the quality is good, the price is acceptable.

This is the second printer of the same type, the first one does not keep up, it works 24/7. This one is to help him. For calibration, I advise you to take a can of beer or another drink, cut out a thin strip with dimensions of approximately 60x20 mm and calibrate it with it, since paper will not give you the proper result. Buy a Teflon tube, as this one wears out and breaks in the area of ​​\u200b\u200bthe fasteners after half a year.

Pros
  • Easy to assemble, but you need to properly assemble YouTube to help you. Good rigid frame, small size, great value for money. If you need a car that will plow for days and even months, feel free to take it.
Cons
  • Noisy, you need to change the motherboard because stepper motors are noisy on the native board, fans, completely the filament supply unit (for the first time it will do, after a year of operation it cracked in the bearing area, replaced it with an aluminum block, there are a lot of them for aliexpress for little money). The native mat can be immediately thrown into the trash, replacement with glass is unambiguous, you can cut any glass to fit the table size, I have a simple matte not hardened one.