Review on 🧵 Versatile Adjustable Tap Bias Binder Foot - Compatible with Singer, Brother, Babylock, Janome, and More! Adjusts from 5mm to 20mm by Kristen Reid

After I removed the extra plastic (see below) everything worked fine. I've only used it for 1/4" double-sided binding. You need to start binding over the plastic guide guide without lifting the presser foot off the machine. You may need to pry it out with an awl or needle. Turn the screw on the Back determines the position of the needle on the edge.The thumbscrew on the side keeps the piping pressed to the left against the edge of the fabric.When installing the thumbscrew, ignore the mm mark;and then complete the pattern by adjusting the thumbscrew to do so that the fabric sits snugly in the crease of the interlining. Mine looked like it was squeezing the interlining a bit when adjusted correctly. The fabric should stay in the groove, all on the right edge so it fits snugly The fold of the attachment was seated The slot is thin so this foot is not suitable for tying thick material Initial problem with my device: The slots where the tape comes out were throughc h thin plastic blocked so the tape couldn't be pulled through. This thin plastic comes from a plastic mold g process is called blinking. It was supposed to be removed during production, but in this case it wasn't. A few minutes with a magnifying glass and a sharp blade and I erased it.