I used the 1/0 gauge wires and two 1/0awg to 4awg distributions blocks to relocate my battery. The only problem I had was the cable going to the starter was 2awg and the outlets for the block was 4awg. I did not want to use a reducer because I wanted a clean look so I took the block and drilled out one hole to gauge it up. The material was quite soft making the cut very easy and clean. Unless you pulled the wire you would not know the difference.The only thing I would complain about if I was to nick pick, is the backing plate screws protrude through the bottom holes. If you have a tight fit you will need to back these out a little and then retighten after the wire is in. For me, this was no problem.
SilverStone F1 Monaco S radar detector
82 Review
Compact USB-Powered Desk Fan With Four Speeds, Strong Airflow, And Quiet Operation - 310° Adjustable, Portable Mini Fan For Home, Office, And Bedroom (Navy Blue)
35 Review
Bundle: Bracket 3 Cup Set & 6 FT Power Cord for Beltronics & Escort Radar Detectors (Accessory Bundle)
34 Review
Smart Column Yandex New Station Mini - smart column with Alice (with watch), black onyx
432 Review
🔍 MANN-FILTER W 811/80: The Optimal Oil Filter for Enhanced Engine Performance
11 Review
🎧 FARO Aviation Headset Converter: Low to High Impedance Adapter for General Aviation (GA) and Military Headsets
9 Review
✈️ Enhancing Aviation Safety: ASA-OVC View Limiting Device for Clearer Vision in Overcast Conditions
9 Review
🗺️ CARRVAS GPS Navigation System for Car, 2021 MAP 7inch Truck GPS Navigation, Spoken Turn-by-Turn Directions, Speed Warning, USA, Canada, Mexico, Lifetime Maps Update
9 Review