Review on 🔍 JT148RR SE Ring Stretcher and Reducer - Enhanced SEO by Heather Shaw

Think about where the bad reviews are coming from. Nobody blew up the unit by stretching the ring. All are on the base of the reduction plate during reduction and rotation. If you only use it for stretching then there is no problem. When downsizing, take the time to harden the tool. Yes, you must do it, because to avoid this, you would have to pay more than $200 for a turnkey stretcher. The base of the tool is hollow, and all that force would split anything that didn't have a support underneath. A piece of 1" steel and JB Weld under the adapter plate and your tool is as strong as a $300 tool. Don't change the screws, it won't help the jack. There are no breaks in the bolt holes. Take all the bolts out and wipe off the cheap oil they splattered on and wrap them in teflon to keep them from loosening. Take the whole block apart and apply blue bearing grease to each inside and you won't have any frictional stress ruining your tool. The assembly crew is probably making $5 a week doing nothing but rust prevention. Now you can leave everything as it is and soon wait for another copy of the same purchase to be delivered. makes $5 a week and all they care about is rust prevention. Now you can leave everything as it is and wait for it soon that another copy of the same purchase will be delivered. makes $5 a week and all they care about is rust prevention. Now you can leave everything as it is and soon wait for another copy of the same purchase to be delivered.