Review on TC Motor Hydraulic Cylinder Motocross Motorcycle by Nathan Pintac

I was looking to buy higher quality hydraulic clutches for my kx250 but decided to try these on my smaller bikes and I got lucky. I installed one on a Pirahna YX140 engine, bled it and it works great. This is easy to do with one or two fingers, and the lever has adjustable reach and folds. Then I bought a second one and installed it on the KX80 that I have and it works very well too, much better than a good MSR clutch lever and new cable as before. The leash is quite long for small bikes, so the banjo bolt on the slave cylinder may need to be loosened to allow you to move the leash, as well as the banjo on the tank to get the leash working the way you want it to. Pumping is very important, but not difficult at all. That's about 5 minutes of work with a 5mm allen wrench, a Phillips screwdriver, brake fluid and a rag. In the long run I'll see how it holds up, but after about a month of use I'm satisfied and would recommend it. It's amazing for the price.