
There are several rooms with ic classified cans but the ceiling they are fitted in is an outdoor floor! There is no insulation between the glass and the cold ground above. In our case, an instant-read thermometer indicated our recessed lights were 48 degrees when it was 62 in the room and 60 on the ceiling (at 37 St). Looking for a safe way to reduce heat loss without tearing the blanket, lots of bad options and then this great single wire connector, bend back the mounting springs and stick into the glass... push/twist/push gently on the mount. to sit flush with the ceiling...there is a thin foam strip that sits between the ceiling and the fixture. Some of my lights didn't sit perfectly flush, leaving an annoying gap between the light and the ceiling. I put two dabs of Kahn cement on the outer ring, waited for it to dry, and then pressed it against the ceiling. The color of the lamps is excellent, perhaps the only complaint is that they are a bit bright. the rest of the house. Total assembly time 6 was about 15 minutes including using drops of glue to press the trim firmly to the ceiling.