Review on 12V Dimmable LED RV Lights - Waterproof Interior Ceiling Lights for Motorhome, Sailboat, Yacht | ALOVECO - Pack of 8 by Bryan Hill

I have 15 more to install I have spade terminals on them - male to - and female to + so I can install them in my new house in the garage. workshop and relaxation room. I make all lighting 12 volts for power, duration and ease of installation (no ground wires etc). The only one installed works great. It would be nice if the wire was stripped a little more and not tinned the end. These things make me work harder. When I have time I may come back to add to this review once the entire garage and workshop has been lit and tested. I may even have photos. EDIT: I installed eleven. They work very well for this purpose and are much easier to connect than 120V incandescent bulbs. Mind you, I had to do some special things. I put quick-release fasteners on the wires to allow the ceiling material to be installed. I bought some box covers and drilled light and screws into them. Electrical testers here in California almost completely ignore low voltage circuits. Therefore, my amateur wiring will not cause any problems.