Review on 🔥 WB13K21 Replacement Igniter from the PRYSM Range by Brian Stepp

I ordered this late Thursday evening and it arrived Saturday afternoon. I have a GE lineup that is about 4-5 years old. .2 screws hold the bottom of the oven. Remove and lift the back panel by pushing towards the back of the oven until the front edge of the bottom panel is under the front frame. Then lift them out of the way. You will see the igniter on the left rear of the burner tube, held in place by two more screws. Follow the wires and you will see a panel located in front of the gas regulator. from underneath. Loosen the screw and slide the panel to the right and slide it to the side. You can see where the wires go to the back of the board. There, the round plate is held in place by a single screw that holds the connector from being pulled out. You can loosen the screw just enough to flip the panel to the side and manipulate t it connects through the hole. The connector fit right within my reach, so I didn't have to cut and splice wires. Turned on and performed the reverse process. Everything fits perfectly and works great. The whole process took about 15 minutes. .I gave 4 out of 5 just because I don't know how long it will last. But that's less than half the cost of buying a replacement igniter from GE.