Review on 🦄 DECO65 High Gloss Unicorn Blue-to-Purple Opal Holographic Craft Vinyl Roll for Die-Cutter and Plotting Machines - 3ft x 12 by Angie Baker

Like others who left feedback, my vinyl roll had defects/creases when unrolling (see picture). I actually separated the vinyl from the backing and was able to successfully iron out most of these creases before cutting, although this was NOT an easy process and should never be done. Unfortunately, the problems didn't end there. I used my Cricut Explore Air 2 to attempt to cut this vinyl. The results were less than satisfactory. You'll see in the picture above that the vinyl doesn't cut well even after weeding - I really think it's because there seemed to be a real sticker side to stick it on - that substance of the sticker stuck to it itself .and allowed no smaller net cuts. As I pulled the sheet out of the cutting mat (and I was using the LIGHT GRIP mat) the backing paper began to tear leaving large chunks on the gripping mat. I had to use a razor blade to remove it from the grip mat.