Review on Ogrmar Needle Point Tracing Handle by Kelly Caballes

This is for you plastic model makers. This tool is very sharp and makes nice round recessed "rivets" when rolled over styrofoam. The 400 paper passport eliminates the "volcanic" look of the displaced plastic. So the harder you press, the more "dimples" will remain. I had to add a few shims on either side of the wheel to get it moving straight and without hesitation. The bolt and nut holding the wheel are immediately unscrewed and you can adjust the tension depending on how much the wheel will turn with the nut. The gap between prints is 0.13 when rolling on a flat surface. I was able to use it on a hanging tank less than 1 inch in diameter. You need firm pressure and a steady hand. You can place a point at the end of the row and continue riveting in one or more directions. m to use to make 1/32 scale aircraft plates and the distance between them is about 4 inches in 1/32 scale. Much luck.