Review on 🖥️ Enhance Productivity with Mount Plus MP-XMA-12 Dual VESA Bracket Adapter: Transform Your Single Monitor Setup into Dual Screens up to 27 inches by Robert Schneider

I used this as a wall mount for my two 24 inch monitors. I think it's good value for money, with a few indications. First, some complain that it doesn't fit with mounting hardware. This is a dual monitor adapter for existing desktop monitor mounts. This is not, or intended to be, a standalone wall mount. To use it for this purpose, take a few screws and so on. 1. I screwed this to the post on one side and to the wall anchors on the other using two 1/4" x 2" screws from Home Depot (maybe 60 cents each). .If I were to do it again I would move this mount away from the wall a bit as the mounts don't hit the wall too much. Wall, or I would use some washers between the bracket and the wall to achieve a small gap. Probably washers as that would be easier, but a piece of wood screwed to two studs gives you a little more room to position the mount exactly where you want. The reason I would do this is because this mount isn't quite right for me. The monitor mount was pulled along the wall on the anchor bolt side because that side was tightened more than the wall anchor side. There is some damage on the wall but that's okay. If I ever remove this bracket, I'll still have to patch and paint the screw holes so patching that notch isn't too difficult.2. I've read some reviews that the tilt screws don't hold the monitors in place and they sag. This particular product may have been defective for this reviewer, but I simply pulled a 6mm hex wrench from my hex wrench set and used that in place of the one that came in the box. The correct 6mm Allen key is about twice as long as the one provided, giving you more leverage to tighten this screw to hold the monitors in place.