Review on 𧡠Dritz 896 Heavy Duty Single Cone Thread Holder by Erica Houlf
Bad design with uneven surface for filament spool
This design is good when it comes to being metallic. But it has one major downside. Below is a spot that isn't flat, I don't know why. If your thread spool is not the right size, it will cause big problems. The bobbins force the thread underneath, causing tension that breaks the needle. Happened 4 times already and I just twisted the piece of wire and didn't use the base. Hits most of the target. The bottom must be flat, not concave!
- Dritz-Cone filament holder
- Infinitely sluggish
New products
Comments (0)
Top products in 𧡠Thread & Floss
Pirelli Scorpion Verde 225/55 R19 99V summer
56 Review
Leather Sewing Waxed Thread - 150D 33 Yards Per Spool For Craft DIY, Bookbinding, Shoe Repairing 330 Yards
11 Review
364-Pack Embroidery And Friendship Bracelet Floss Kit With 200 Vibrant Colors And Cross Stitch Tools By INSCRAFT - Perfect For Embroidery, Cross Stitching, And Bracelet Stringing
16 Review
6 Green Shades Pearl Cotton Thread Set - Threadart 75Yd Spools Size 8 Perle Cotton For Hand Embroidery, Crochet, Cross Stitch, Needlepoint, And Friendship Bracelets
15 Review
Another interesting products
𧲠Enhanced Magnetic Large: Basic 8 Inch to 32 Inch Size for Optimal Performance
9 Review
π Tulip One-Step Tie-Dye Kits Rainbow - 5 Colors, 1.62oz
7 Review
Easter Egg Decoration Kit: Lot of 5 Heat Shrink Wrap Sleeve with Flowers and Icons for 35 Eggs
8 Review
Craft Tool Quickstik by We R Memory Keepers
7 Review