Review on Deepcool Redhat CPU cooler, white/red/black by Kiril Tankard ᠌

The first minus: I'll start with the fact that it is installed on a standard backplate on the socket: AM4 and after the first bolts are tightened, it hangs like a snot. The second minus: this is thermal paste, which I just didn’t smear the processor with, but this is the highest d * . well, maybe it transmits temperatures well, I haven’t figured it out yet, but there’s nowhere to apply worse. At first it is normal, but after 30 seconds in the air it turns into chewing gum. It is better to apply liquid metal, which also has its own characteristics in application . Third: when the processor is covered and you need to tighten the bolts on the sides, new difficulties begin. a) if you don’t immediately try on the swing and don’t place the bolts so that they fall into the grooves, then you will then run out while you look for a position to tighten them. b) you got into the grooves, a new quest, find a screwdriver 20 cm long in the house. If there is none (I personally had 13 cm). That adventure has just begun. You screwed a bolt into one groove (on the side where the RAM is), but on the other: D I will say this installation took me two hours due to the lack of a suitable screwdriver 😀. ZY why not equip one? Unclear.