Review on 📺 Top-Rated A1Cover Outdoor 55" TV Set Cover: Scratch-Resistant Liner for Ultimate LED Screen Protection - Perfectly Compatible with Standard Mounts and Stands (Black) by Jesus Baker

I bought a case for a 50" Samsung 44" TV, so a case for a 50" TV. The fit is pretty good, the width is about right, it's a bit tall as the TV is 25" and the cap is 29", but not bad. It could be a few inches thinner as it looks a bit baggy. Love the zips and the easy folding of the front cover, our TV is 1.50m off the ground, so it's easy to get to. There are clear plastic clips in the corners to prevent the cover from sliding off the back of the TV when the front bezel is up. that's a good feature. The only part that I think needs redesigning is how the wall mount mount attaches to the TV. The opening at the back is a large square with Velcro and a second keyhole opening. I have a wall mount with a single bracket, but since the brackets match the TV, the bracket isn't in the middle of the back wall, it's closer to the top of the TV. As a result, there's no way to lower the flap to close the back where the arm attaches. It would be nice, if they would supply a cone cut piece of fabric that could be placed on the hand and then attached with velcro to the back of the case. Right now, 6-8 inches of the back of the TV is open to the elements. If you look at other cases, they seem to be the same in this regard. Otherwise the material looks high quality and should hold up. for a few years I guess. The only part that I think needs redesigning is how the wall mount mount attaches to the TV. The opening at the back is a large square with Velcro and a second keyhole opening. I have a wall mount with a single bracket, but since the brackets match the TV, the bracket is not in the center of the back wall, but closer to the top of the TV. As a result, there's no way to lower the flap to close the back where the arm attaches. It would be nice if they provided a pre-cut piece of fabric in the shape of a cone that could be slipped onto the arm and then attached with velcro to the back of the case. Right now, 6-8 inches of the back of the TV is open to the elements. If you look at other cases, they seem to be the same in this regard. Otherwise the material looks high quality and should hold up. for a few years I guess. The only part that I think needs redesigning is how the wall mount mount attaches to the TV. The opening at the back is a large square with Velcro and a second keyhole opening. I have a wall mount with a single bracket, but since the brackets match the TV, the bracket isn't in the middle of the back wall, it's closer to the top of the TV. As a result, there's no way to lower the flap to close the back where the arm attaches. It would be nice if they supplied a cone cut piece of fabric that could be placed on the hand and then secured with Velcro on the back of the case. Right now, 6-8 inches of the back of the TV is open to the elements. If you look at other cases, they seem to be the same in this regard. Otherwise the material looks high quality and should hold up. for a few years I guess. open to the elements. If you look at other cases, they seem to be the same in this respect. Otherwise the material looks high quality and should hold up. for a few years I guess. open to the elements. If you look at other cases, they seem to be the same in this regard. Otherwise the material looks high quality and should hold up. for a few years I guess.