Review on 🖨️ Creality LD002R Printer: Advanced 0.15mm Precision Release by David Edwards

After reading some bad reviews for this product I decided to find out for myself if it really was a failure. Well the first time I replaced my FEP with this one I noticed it got a lot thicker and a bit cloudy. I installed it anyway, and of course my 5 hour print failed about halfway through. Discard the FEP and try again. This time I worked very hard to peel off what appeared to be a protective film. And so it was. The clouds have become much smaller. Install, print, crashed again about halfway through. I noticed that each FEP error was twofold. Then it dawned on me, FEP was squeezed between TWO layers of protection. Last try. Remove both protective films, attach, print, good luck! Good thing I got all 6 from me, unlike one of the reviewers. Great product, does what it's supposed to. I wish they had mentioned the screen protector. For your health !