Review on 🌈 YORMICK LED Strip Lights - 32.8ft/10M 300 LEDs, RGB Color Changing, Waterproof, with Remote Control - Perfect for TV, Bar, Bedroom, Kitchen, Party by Tyrell Rike

The remote control has many buttons, but only half of them are really needed. Some of the buttons have unexpected results, or at least do something that doesn't quite match the abbreviation or icon on the button. bad things. The same goes for any part of the strip (more on that below). Not the brightest strips, especially if you power the entire strip. It is possible to use a slightly higher capacity adapter to get a little more juice through the lines and for safety reasons not to exceed 70-80% of the adapter's capacity in continuous use scenarios. This is not a continuous strip, but several smaller strips that have been soldered together. It doesn't matter unless the solder is bridged or it's right where you need to cut and use a corner adapter or something. It's very nice to call it "double-sided tape" on these tapes. The glue hardly sticks to anything for more than an hour. Just to illustrate how bad it is, we cut out some 4 inch segments (the shortest length you can cut) and attached them to various vertical surfaces. the plastic of the monitor, the plastic of the TV, the screen and the glass took more than an hour with no details. Each surface has been cleaned with the appropriate cleaners or alcohol wipes where possible. The results did not improve as the strips got longer and heavier. The solution was to completely remove the tape and stick some 1/4 inch 3M brand tape on them and removing the adhesive from them is no easy task. In a nutshell. buy something else.