Review on 🚚 Rear Trailer Hitch Receiver for 05-17 Kawasaki BRUTEF750 by Quadboss by Dakota Afzalian

Not the fault of the product. Will not fit directly as advertised if you have a 2" high lift kit. The lift kit includes a support rod that crosses the rear frame and helps stabilize the lift itself. An additional pickup tube protrudes from the back of the pickup plate and catches in the lift kit before the mounting tabs are properly aligned. I cut off the excess material and after that it fit perfectly. Also note that the top mounting screws are barely enough for the receiver plate. Looking ahead, I would remove the bolts and replace them with half inch longer bolts if I were you. Seems sturdy enough to support as much weight as the quad can pull itself, even after sanding down the back of the tube. I will use it for a small log trailer and splitter. Kawasaki Bright Force 750i 2014 Instructions are vague but helpful. It is not necessary to remove the "muff screws", it is not clear why they are mentioned at all. They are left with two bolts from the C-pillar upper support. The movement of the frame prevents them from lining up again. Grab a couple of swivel heads to reattach the bottom screws. The wrench method is intimidating one flat turn at a time. I would recommend it to a friend! Even with small mods.