Header banner
Revain logoHome Page
Denise Davis photo
1 Level
9725 Review
6561 Karma

Review on 🔧 Dremel GS45-01 Adhesive Sticks by Denise Davis

Revainrating 5 out of 5

The first really WORKS!

I had clutch problems with the FLSUN QQ-S Pro. Lots of bad prints in the last month. I set the z height too low and managed to get adhesion but it ruined my duvet. I got a magnetic plate made of PEI spring steel and that didn't help either. Tried hairspray, didn't help. So I decided to give these glue sticks a try before spending any more serious money on specialty bed glue. Well it really works. The purple helps a little to know where you've applied glue and where you haven't, but it helps more once the seal is done and you leave the bed, as you can use regular hot water to give the bed a deep clean, since the Adhesive turns purple again when rehydrated. This is a big help as cleaning the bed and then applying glue works best for me. Anyway, I'm very satisfied and would buy again if a 3-pack doesn't last longer than the printer itself!

Pros
  • Easy to read control panel
Cons
  • New competition has arrived