🔧 Dremel GS45-01 Adhesive Sticks Review

Great, same as my 3D printer. If I'm too lazy to peel it off, it still stays sticky with enough on my plate and I can type over and over again without reapplying it. Also a tip for those who don't already know, just spray on Windex and wait a minute for it to lather and scrape off for easy removal. Currently used with Flash Forge Finder.

When the glue stick that came with my Qidi Tech X-One 2 ran out, I bought a pack of UHU glue sticks after reading positive customer reviews. However, they didn't suit me at all. I lost 50% of my casts due to bad grip on the platform. However, the Dremel GS45-01 glue sticks showed the same pressure adhesion performance as the stick that came with the X-One 2. Now my prints adhere and I don't see any warping. I will definitely be buying Dremel GS45-01 glue sticks in the future.

While this may not work (haven't tested it with other materials), PETG adheres to it very well. Clean the bed with water while it is warm, not hot. Then a good wipe down with isopropyl. Then let it dry. Do not touch after drying, then add a layer. Allow to dry, heat up the bed and print as usual. Do not touch. If you touch your finger, the oil will ruin it, and a light touch is enough to ruin everything. Once printed you don't have to remove it, it literally pops out on its own once it cools…

I really try not to use glue on my prints because I find it annoying. For my last printer it was difficult to find a spring steel plate to match, so I used blue masking tape with the glue method. I prefer this type with purple as it's easier to see where you've applied it than with the standard white. The only thing that bothers me is that the glue sticks run out quickly. However, it's a cheaper and more effective option than some of the liquid pressure glue I've tried here on Amazon. You…

I had clutch problems with the FLSUN QQ-S Pro. Lots of bad prints in the last month. I set the z height too low and managed to get adhesion but it ruined my duvet. I got a magnetic plate made of PEI spring steel and that didn't help either. Tried hairspray, didn't help. So I decided to give these glue sticks a try before spending any more serious money on specialty bed glue. Well it really works. The purple helps a little to know where you've applied glue and where you haven't, but it helps…