Review on 🔧 Dremel GS45-01 Adhesive Sticks by Amy Mcleod

While this may not work (haven't tested it with other materials), PETG adheres to it very well. Clean the bed with water while it is warm, not hot. Then a good wipe down with isopropyl. Then let it dry. Do not touch after drying, then add a layer. Allow to dry, heat up the bed and print as usual. Do not touch. If you touch your finger, the oil will ruin it, and a light touch is enough to ruin everything. Once printed you don't have to remove it, it literally pops out on its own once it cools. Again, I print dozens of prints with this material and the PETG combo and have had no issues with it.