Review on Power bench for bench press (folding) Black by Jnis Kalni ᠌

1 package. I thought that the manufacturer listens to the reviews, but as they wrote in the reviews earlier, it was simply packed in no way, everything was thrown into the box and, as a result, the seat was torn, parts were scratched. 2) Processing. In some places, the welds are not processed and snot hangs, which are painted right on top, in some places it’s just rust. 3) Completeness. In places of rotation, washers are needed so that the metal does not rub against the metal, but if you assemble it wisely, i. E. put washers at all points of articulation of rubbing parts, then there will not be enough washers. The keys in the kit are good, but one key had to be finalized with a file, since the stamping was of poor quality. Nuts without lock, i. E. you will often have to tighten the structure, especially the bolts that act as an axis. 4) Design. The bench is wobbly. This is solved by the selection of gaskets, but they are not included in the kit and the design does not imply this. In general, it is not scary and can be solved in a couple of minutes. The seats are quite flimsy, if you distribute the load over the entire area, then most likely nothing will burst anywhere, but if, for example, you do thrust with an emphasis on the edge, then most likely it will just fall off. 5) Instruction. It exists, it is understandable, but understandable for people with a technical mindset, I think it will be difficult for a girl in the humanities to do it alone.