Review on Sarlai 32 Inch Undermount Workstation Kitchen Sink With Ledge, Deep Single Bowl, R10 Tight Radius, 16 Gauge Stainless Steel Basin by Eric Pavelko

First of all. The sink. It is beautiful, heavy duty, deep. Packaged very well and impressed upon unboxing. The sink alone warrants 5 stars, however the 16 gauge and accessories are specifically why I purchased this particular sink and the accessories fall flat.The first issue we encountered was the amazing strainer. I was so excited about this, however, we have old plumbing from the 1950's. The drain pipe comes out of the wall quite high. We were unable to use the strainer because it would have been too low for the sink to drain. Fortunately for us, we are still able to use the sink with a box store bought strainer. But barely. If your drain comes out of the wall be sure to measure! Not the fault of the manufacturer of the sink by any means.Once the sink was installed and we began putting in the accessories we realized the bottom rinse grid was bowed up in the middle and 4 of the feet don't rest on the actual sink. One of the wooden handles on the colander is loose so the handle moves when you pick it up. These 2 issues are not the end of the world, but the cutting board is warped . It does not sit flat on the groove of the sink so when you use it it rocks and wobbles. It is extremely irritating when using and as I said, the accessories are the main reason I chose this sink.I love the depth of the sink for soaking pots and so forth. The sink takes FORVER to fill. Especially when the bottom grid is in place. I love the look and the durability of the sink itself, and since I have a dishwasher I don't foresee needing to actually fill the sink that often. The ledge where the accessories fit needs a little extra attention when wiping the sink out and cleaning.Overall, I love the sink itself - just very disappointed with the quality of the accessories.