Review on 🛏️ Convenient Swivel Top Bedside Workstation Nightstand with Drawers and Magazine Holder - Wood Finish, Brown by Chad Slaughter

out of the box. After I labeled them all myself, the assembly was successful until the end. The instructions include a parts list that looks like someone with the wrong typewriter added a part "P:35 Pan Head Screw x" below. This screw is never required in the assembly instructions. The parts list in the manual says "M: 6*25 pan head screws x 10". 10 is incorrect as 12 of these screws are required. 2 are needed in step 7 to attach "Part B: Round Tube 40" to "Part 7: Center Wall". 6 are needed in step 10 to append "Part 9: Desktop". to "Part D: Divider [and]" 2 are needed in step 12 to attach "Part 11: Drawer Front Panel" to "Part 10: Drawer Decorative Panel" - BUT THERE ARE TWO DRAWERS - If So you have to repeat step 12. To attach the second drawer you have run out of screws. Since the parts list says two extra screws (P: 35" x 2" pan head screw) that serve no other purpose in assembly, I tried to use them and damaged the decorative drawer because the unnecessary screw [P] is too long. I called Revain because I had everything ready and couldn't send it back. Revain, of course, stocks these things. Stock and cannot just send a piece or two but will send a COMPLETE NEW one from which I took the missing/damaged pieces and finished my desk. The bottom drawer fits. Upper drawer interferes with assembly of "Part 7: Middle panel" (due to pre-drilled holes) too low. Approximately 3/16 inch. See photos. So if I contact my neighbor who probably has a grinder or some kind of dremel I can finally finish the table.