Technically suitable for the 2005 Hyundai Elantra year of release . with California emission requirements hardly. On mine, the holes in the bottom flange weren't straight, so the bolts were skewed. Nothing spoils the job, but I had to adjust the bottom gasket to bypass the studs on the manifold. Also, the top right hole is offset by 1/8 inch, so the motor mounting screw doesn't have enough holding power. the same length. The length was approximately 1/4 inch longer than the OEM recycled front heat shield. I had a clear leak where the top right screw was. Tried OEM gasket but same problem. The device was sent without packaging in a box. In the same box were heat shields and gaskets. Luckily the loose manifold didn't noticeably damage my seals, but I suspect not all of them do. Included in delivery: warranty card. 6 heat shield screws. Engine and exhaust side gaskets. Front and rear heat shield. Stud bolts and nuts for connection on the exhaust side.
TOTALFLOW 646 Mini Muffler 409SS 4.5" Round Width 4" Body 6" Overall Length Inner Inlet-3.5" Outer Diameter Outlet
39 Review
50' Titanium Exhaust Heat Wrap Roll For Motorcycle Fiberglass Heat Shield Tape With Stainless Ties By LEDAUT 2
28 Review
Nokian Tires Nordman 7 175/70 R13 82T Winter
45 Review
Vapor Canister Purge Valve Solenoid 1997278 For Chevrolet Trailblazer, Cavalier, Pontiac Bonneville, Oldsmobile - Replaces 214-641, 214-2246, 911-035 - EVAP Emission Purge Control Valve
30 Review