Review on 🔌 Enhance Your Audio Experience with InstallGear Gold Banana Plug Connectors - 24-Pack (12 Red, 12 Black) by Jennifer Glasheen

Great product! I finally switched my home theater to banana plugs, any system reconfiguration in the future will be easy now. The pin header and receiver connector of each banana plug are high quality and scroll very well when twisted down. The landing in the receiver of both the speaker and the receiver is good and tight, there is no backlash. The red and black washers/indicators can be moved from one connector to the other. Of the 24 banana plugs I made yesterday, I had to replace one after a sound test on my Yamaha, I had reversed the polarity on the rear right surround. Take your time and do it right when you receive the package. I found that about an inch and a quarter of my speaker wire's screen strip was near perfect. You'll want to strip it a little longer so you can cut it off once you thread the copper through the banana plug's female connector. If you're lucky enough to go a little longer, you can just trim it down to an eighth of an inch or whatever you need. When I originally bought them I was concerned they wouldn't work well with my monster cable, but they fit very well over the copper on this cable. It took a while to install all 24 but the long term benefit is that I can very easily unplug and plug my speaker configuration back in when needed as I'm still trying to do a dweet point setup in my living room to find. Having two bare copper wires in both the speaker stand and the back of the receiver is time consuming at best and can be very frustrating when working in tight spaces. Putting banana plugs on all my cables will make any future reconfiguration very easy and if you think about it I'd definitely give it two thumbs up.