Review on 3D Printer Creality Ender 3 Pro Black by Petar Popchev ᠌

I think that if we slightly modify the Z-axis motor mount, add a belt tension adjustment mechanism, and pressure rollers with a shock absorber, then it would be cool. Got pros: First printer. Printed immediately without unnecessary trials and settings. Cons: The instructions are not entirely clear. So I also looked on the Internet. The Z-axis motor, despite some comments that the manufacturer had eliminated, had to glue the electrical tape under the plastic mount that is attached to the profile. Otherwise, the Z-axis shaft was tilted towards the vertical profile. Although the manufacturer probably still did something with it, since I saw spacers of considerable thickness on the forums, and I only have two layers of electrical tape. I think in general to redo the motor mount so that you can set it up as you like. Maybe the manufacturer should think about it. There are also complaints about the geometry of the guides and the Z axis. If it is more or less clear with the axis that another steel, etc. is needed for its manufacture, then the guides come in a wave and it turns out that it is not possible to adjust the pressure rollers, as it is recommended to do this. . They either "hang in the air" or "I can barely squeeze through. " If the profile does not come out even, can you at least change the design of the clamp? With a spring there is some to compensate.