1 Level
329 Review
0 Karma
Review on ๐ Sturm ER1120PC Milling Cutter - 2kW, Constant Electronics, Price in 6/8/12mm by Mateusz Michalak แ
Second-rate product, won't buy it again.
Itโs not suitable for leveling the surface. After milling, there are stripes that the grinder did not remove the P40 sanding sheet. Before this, there was a Caliber. The strips were also, but not so deep, and the grinder removed them with a P120 sheet. the same plane with the milling cutter, and therefore the cutter goes at an angle. I do not recommend the milling cutter. I will take it under warranty.
Pros
- Soft start, maintains speed under load.
Cons
- Backlash in the guides, the springs in the guides wedge, the lower platform is not in the same plane with the router.
