Review on 🔒 Corrosion Inhibitor Penetrant with Fluid Film Technology by Michael Jennings

I used this product to coat the undercarriage of a Toyota 4Runner to prevent rusting. It's very handy to use a primer spray gun (widely available from Revain). I used 3/4 gallon to cover the frame. It would probably take a full gallon to cover the frame and lower body. The material is thick, but still pours easily into the spray tank. I haven't had any problems with constipation. I used to use Fluid Film aerosol cans. Using a gallon can with an air compressor and a sprayer is easier and more economical. It was also faster since you're spraying at a faster rate. I have used a 5 gallon 110 volt compressor set at 60 psi and have had no problems. Others say that a large compressor is needed. I didn't think so. I will apply annually. This is the second time I have used Fluid Film and I have noticed a reduction in neurost formation. I didn't cook anything except knock off a few flakes of old rust. I recommend this product as a rust preventative for those who drive on roads where road salt is used.