Review on 🔦 LEDIN Fog Lights for 2012-2015 Tacoma - OE Style Clear Lens with Bezels, Wire Harness, Switch, Bulbs: Improved SEO by Brian Wolf

Headlights look great and are bright. They match my 2014 Toyota Tacoma truck and look great. The lamps mount internally, one side goes into the grommets and the other side uses the existing screws to mount the lamps. Use the 4 screws provided to attach the two lights as the ones supplied with the lights are too big and will chip the plastic a bit. By removing the two fender bolts on each side, the fender can be removed to allow easier access to install dual fog lights. I routed the wires through the rubber boot after cutting out a notch to allow the wires to pass through the firewall. Cut the wire harness and route the wire end of the switch connector from inside the cab into the engine compartment and solder and wrap with heat shrink solder joints. The extra red wire at the end of the switch was routed through a rubber boot in the firewall and connected to an extra fuse to the low beam fog lamp fuse in the engine compartment fuse box. If you plug it in here, the headlights will only work when the low beams are on, turning them off as instructed in the owner's manual. Used an extra wire to get to this fuse. wrapped the entire wire with an additional winding.