Review on 🔧 Rosewill 2.5 Inch SSD/HDD Plastic Mounting Kit for 3.5 Inch Drive Bay - Black, RX-C200P - Ideal for Component Installation by Shawn Hodges

I got this along with four Rosewill Serial ATA III 10" red flat cables with latch support 6Gb/s, 3Gb/s and Bought 1.5Gbps transfer rate model RCA-RU-10-SA3-90-RD to upgrade my hard drive cables to SATA III and install a new SSD drive in my computer I used this mount with a Crucial 128GB m4 2 .5" SATA 6Gb/s CT128M4SSD2 uses SSD mounted on Cm 830 Black Stacker. Below is a list of pros and cons I have found with this product when using it with my gear. --- Serious Company - Low Price - Screws are included and there were enough screws to install 2 SSD hard drives and more screws to install in computer case Cons-------------Plastic, not so strong and durable like alum inium or metal. The screws were a little tricky to get into the SSD I attached here, it didn't seem to line up perfectly with the holes on the SSD, it took some effort to get all the screws in. Depending on the computer case, this SSD bracket may move inside the computer case. The screwless design of my Cooler Master Stacker Evolution 830 case means that this adapter doesn't hold up when the drive locks are engaged, but I've had no issues with my other 3.5" drives not holding up in my case, eh e.g. a floppy disk, a floppy disk drive (yes I still have one) or a 3.5" card reader. It would probably be more durable and hold up better in my suitcase if this product were made from a more durable material such as aluminum or metal screws and made by a reputable company.I don't like that it's plastic and the build quality could be better but it's cheap and gets the job done.If you really don't care about build quality and just want something that works then go for it this is a good holder adapter that gets the job done at a great price.