Technically these brake piston pullers "worked". Technically. Although they served their purpose, I was only able to use them once and then they were complete and utter garbage. thrown out. Garbage. Disappeared. Due to the incredibly poor tolerance on the pivot's center hole and the inferior rivet that secures it in place, don't expect to mess up the ever-loving damn bore of your pistons. The substandard steel used for gripping surfaces leaves much to be desired; they are knurled, but the lack of any hardness in the steel causes IMMEDIATE failure of the knurled surface. The case is made of low quality stamped steel with a layer of zinc sheet applied to it. It is also not hardened by it, so it bends and deforms without the slightest pressure. I had to spend four times as much and buy a famous brand with thousands of high reviews. I went cheap and bought a disposable tool. don't be me
🔧 Adjustable Engine Cylinder Hone Tool - EWK 1-1/4 to 3-1/2 Inch 3 Stones, Deburring Piston Honer with 220 Grit
9 Review
ABN Brake Drum Tool Kit - 15-Piece Service Brake Kit with Spring Pliers, Brake Spoons, Pad Gauge, Brake Spring Tool
9 Review
🔧 Lang Tools 279-5420 279 Brake Caliper Press: The Ultimate Solution for Efficient Brake Caliper Maintenance
9 Review
🔧 BMC Universal Vacuum Pump: Handheld Brake Bleeder Kit Ensuring Efficient Auto Service & Food Canning with Brake Bleeding Tester Set
9 Review