Review on FLSUN Pre Assembly Auto Leveling Φ260330Mm Printing by Michael Moonin

I love this thing. Setup was easy and took maybe 10 minutes, the screen is very fast and responsive and I was able to set the Z offset, auto level and print a near perfect 19 minute bank (150mm/s) right out of the box. I'm just getting to 200mm/s and it's crazy to see how this thing works! I also own a couple of Ravens and a Prus and am amazed at how much tech you get for the money. Extruder clone BMG, ultra-precise Clickizond. Volcano Clone Hotend, Filament Beat Sensor and SKR 1.3 board. For now I've upgraded the case to ASA (1/2 weight), fitted 2 5015 fans and ducting for most of the cooling, installed a bimetal thermal break so I don't have to worry about bowden tubes and over temps over 240 , real volcanic block and Swiss nozzle 0.4. I also installed clipper on it and ran input shaping to optimize acceleration and reduce ringing. It sounds like a lot, but the parts were easy to print, and the thermal break and volcano block together cost about $25. The only downside so far has been finding and supporting replacement parts. I emailed them 4 days ago asking them to buy some spares just in case (extra bed, extra probe etc.) but still no response. Spare parts are difficult to find domestically. All in all, this printer is very efficient. It's easy to set up and calibrate, extremely fast, comes with lots of great components, and seems reliable. Best of all, it's very fast and a lot of fun to watch it work!