Review on WALI GSDM003 Premium Triple LCD Monitor Desk Mount - Fully Adjustable Gas Spring Stand for Displays up to 27 inches, 15.4lbs Weight Capacity - Triple Arm - Black by Avishai Menon

After purchasing the Echogear triple monitor and finding that I can't adjust the side monitors inward enough to my liking for a business environment (this is perfect for a gaming environment but I have I open a few spreadsheets every day and I want the very edge of my eyes to be the same distance from the center of the screen). I bought this mount. That being said, I decided to buy extra long cables for my three installed monitors, as well as some spacers for my desktop and a black speaker wire. Cables through (mic, phone charger and speakers) I have to say it's now a nice clean setup with cable management built into the Wali cable covers (included). Then they just come out the back at the bottom where it attaches to the table. I think that could still be improved. I've only attached it to the edge of the table at the moment, but would be happy to drill a larger hole if they could figure out a way to make a table grommet. can go inside the rack from the cable management system and then exit at the bottom (which exits at the bottom of the table). That's the only thing I can think of to make this setup perfect. Good news Vali, if you develop a new Center Post Mount solution that does this (attaches to the table and has a slotted hollow tube on the side) it can be retrofitted to these setups if you use the same diameter. I find it can be difficult to fit all 6 cables (both power and video) in it, but if people buy very thin video cables (HDMI or other) I think it will fit. This will be the final install. I'll take pics maybe next week when I get the grommets and route the speaker wire and other cables under my desk. Overall, this mount still gives me the angles and adjustability I need and does a 4/5 job with cable management. Add a new center post with slots that run through the sides in multiple places and an open base that can be installed through a hole in the table so all the cables just run under the table and that would be perfect!