Review on Silver Baseus Cube Gravity Vehicle-mounted Holder by Adam Woniak ᠌

This attachment might use some improvement. We remove the ball, then unscrew the screw that is located underneath it. We disassemble the body by carefully prying apart the two sections with the blade of the knife. We are able to recall the arrangement of the components. I cut the spacers in width to the size of the guides of the vertical foot, and I cut them to the entire height of the lid. One spacer was made of cardboard, and the other was made of thin plastic (a sour cream cover is perfect), and I mounted them in the back of the case so that the vertical foot could move on them. I drilled a square hole for the sake of simplicity in the gasket at the location where the gear had been inserted in both of the gaskets. We start by putting things together in the wrong sequence, then we snap the case, and last we secure it with a screw that taps itself. The components move with comparatively little effort, but there is no longer any chatter. You also have the option of adhering a portion of the door seal to the left side of the lower foot, although the configuration of the torpedo will determine whether or not this step is required.