Review on 10PCS Rhymad Conductor Compact Lever Connectors With Fixed Base, 28-12 AWG Electrical Wire Terminals For 2 Circuit Inline Splices (SPL-2) by Ronald Cambridge

I got this to splice jumper clamps on my battery charger which came with some weird ass connector that was a pain to put on and take off.Now I have normal, standard jumper cable clips to connect my charger.Very solid, meet all the local electrical codes, quick and easy. Just cut the wire, strip off 3/4 inch, insert and clamp down. Done. Not worried about stress or pulling out.I used one like this with 3 slots to add a new outlet to an existing line that only had a couple inches of play, so didn't have room or slack in the wire to use wire nuts to splice in a new wire.So cut original wire (one black, 1 white, 1 green).Need 3 of these splicers, each with 3 inserts.Inside an electrical box (I used a thin / flat one).One block for all the black wires: - Put original black wire source into slot 1 & clamp down. Put original other end of same black wire in 2nd slot and clamp down, add 3rd black wire for new outlet into 3rd slot and clamp down. Now all black wires are bound together. - Do same for all 3 white wires (all 3 in one three-slot junction box) - Do same for all 3 green / ground wires.Presto, instant new wire to run to new outlet I was installing in ceiling of porch for camera.