As mentioned, Orbitkey overprices the rubber key holder; However, they designed it well. The hardware pieces are well made and have a smart ratchet lock on the post that tightens every 180 degrees to keep keys/components in place. However, I still found the keys to be a bit loose, not because of the Orbitkey's design, but because the hole in my keys/flash drive was too big and they were misaligned on the stand. Attached are a few photos of the modification I made to the keys and drive which fixed the looseness. I used some JB Weld Quikweld (an epoxy that is around $5 at your local hardware store) to fill in the holes. After it has cured for about 10 minutes you can trim it flush with a razor blade and let it dry for another 4-5 hours before sanding it smooth and drilling a new hole. I used a 9/64" bit which adds little preload to the Orbitkey shank. The keys now remain centered on the post, and since the keyholes rub a bit, no post is required. Finally, I used two #6 flat washers (also bought at a hardware store) on each end of the post, along with one of the wave washers, that came with the Orbitkey, which improved the ease of opening.
Custom Engraved Silver FAINOL Boyfriend Keychain
27 Review
Titanium Keyring by BANG TI: Easy-to-Use Operation for Ultimate Convenience!
50 Review
Carry Your Love For Firefly Everywhere With QMx'S High-Quality HD Key Chain
34 Review
Ultimate Titanium KeySmart: A Must-Have Organizer for Men's Accessories
49 Review