Review on 29V/24V 2A AC/DC Power Supply For Lift Chair & Power Recliner With AC Cord by Christopher Kumar

The cord between my old power supply and the chair got crushed in the chair rocker, apparently shorting and it took out the power supply. I bought this power supply knowing it wasn't the exact replacement for my Lazy Boy recliner. The original power supply had a 5 or 6 pin connector where it connected to the chair. If anyone can find one of those, do us all a favor and share a link. Even though it had a multi pin connector, there were only 2 wires in the cable. I cut the old cable at the break and rigged up a temporary 2 prong plug that work with this new power supply. The chair works great. At first, I had the wires reversed so the up buttons were down and the down buttons were up. After switching the wires, the chair now works like it is suppose to. I have two of these chairs so I did a full recline speed test between the chair with this new power the supply and the one with the original supply and they were both the same speed. I will probably cut the connector off of this new power supply and splice the old cord end wire to wire now that I know it works. One little side note, the original power supply box is a larger than this new one, probably just because the original had a 9 volt battery backup where this new one doesn't. So if the the chair is reclined and we have a power outage, the chair will be stuck in the reclined position. That's not a big deal for me. But if it were, I have a second chair I could borrow the power supply from to lower the chair.